AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 521

PRI Facilities
Console Display/Instructions
2 Save your entry.
Enter Enter
Select .
3 Erase the current telephone number ( n ).
NNN
N
4 Enter a telephone number of up to 12 digits to send
( N = any combination of 0 to 9).
5 Continue to assign the telephone number to another line or go to Step 6.
Next
Next
Select .
6 Save your entry.
Enter Enter
Select .
7 Return to the System Programming menu.
Exit
Exit
Select two times.
Test Telephone Number
Use this procedure to assign a test line or trunk telephone number for each
100D module installed in the control unit.
The number assigned to the test line/trunk must be different from the numbers
assigned to other channels in the same B-channel group. It must be the same
number as that provided by the PRI service provider.
Summary: Test Telephone Number
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Additional Information
xxx = line entered in Step 1
Press Drop.
Dial or type [ N ].
Return to Step 3. The next line will be
displayed on Line 1.
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
Telephone number of up to 12 digits
Programming Procedures
PC
2
+
4–149