Idle States - AT&T MERLIN LEGEND Release 3.1 System Programming Manual

Idle States

Exiting System Programming
Use the information in Table 1–4 to return to the System Programming menu, the
main menu (Menu Mode screen), or to the Home screen from within a
programming screen.
Table 1–4. Exiting System Programming
To return to ...
Previous menu
Main Menu
Normal call
handling
Idle States
Some programming procedures can be started only when the entire system, or
some part of it, such as a trunk or an extension, is idle (not in use). Some
procedures require that a trunk or extension be idle only at the instant of
programming. Lengthy procedures require the system, trunk, or extension to
remain idle until programming is completed. These procedures wait for the
system, trunk, or extension to become idle and then prevent the initiation of any
new calls. This condition is called forced idle .
NOTE:
If a procedure requires an idle condition, do the programming outside of normal
business hours.
If a procedure requires that the system be idle and the system is busy when you
begin, you see the screen shown in Figure 1–12.
1–42
Programming Basics
On the console press:
-NEJ
Menu
Home
#
On the PC press:
A
D