AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 409

Communications system
Hide thumbs Also See for MERLIN LEGEND Release 3.1:
Table of Contents

Advertisement

Lines and Trunks
Toll Type
Use this procedure to specify whether users have to dial a toll prefix (1 or 0)
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each line/trunk.)
This setting is used by the system to classify calls as local or long distance so
that appropriate toll restrictions can be applied.
NOTE:
This option applies only to loop- and ground-start trunks; it does not apply to tie
trunks or DID trunks.
Summary: Toll Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
PC Procedure
System manager
All
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Toll prefix required
Required, Not required
No
Yes
®
LinesTrunks
Toll Type
®
®
Enter
the line/trunk
To program a block of lines/trunks:
LinesTrunks
Toll Type
Enter
Toggle LED On/Off
To program a single line/trunk:
Type no. of the line/trunk
To program a block of lines/trunks:
Select block of lines/trunk
On/Off
®
®
Select entry mode
®
®
Exit
Exit
Exit
Select block of lines/trunks
Exit
Exit
Exit
Toggle letter
Programming Procedures
Dial no. of
G
4–37

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MERLIN LEGEND Release 3.1 and is the answer not in the manual?

This manual is also suitable for:

Merlin legend 4.0

Table of Contents