AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 84

Installing the SPM Software
NOTE:
The attribute is also specified in ams.cfg as
DEBUG
setting, or
feature of SPM, activated by pressing
edit the ams.cfg file; it is not part of the initialization process. The DEBUG
attribute is for use by qualified service personnel only.
Table 2–1. SPM Configuration File (ams.cfg) Options
Option
Follow the steps below to perform the SPM initialization.
spm
spm
1 Type and press
Make your entry at the
Make your entry at the
2 Press any key.
X.XX
The screens shown in Steps 3 through 7 appear only if the system has not been
initialized. Otherwise, the screen shown in Step 8 appears.
2–6
Programming with SPM
(on). This attribute is used to enable the Escape-to-Shell
Use
Specifies COM1 as the serial communications port
used by SPM
Specifies COM2 as the serial communications port
used by SPM
Specifies modem speed of 1200 bps
Specifies modem speed of 2400 bps
Specifies color monitor
Specifies monochrome monitor
Specifies English as the PC language
Specifies French as the PC language
Specifies Spanish as the PC language
to display the SPM Welcome screen shown in Step 2.
prompt if your PC has a hard disk.
prompt if you are using the floppy drive.
X.XX = current version of SPM
(off), the default
+ . To turn DEBUG on, you must