AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 33

Programming Procedures
Console Display/Instructions
4 For additional toll services, go to Step 1; then continue with Step 5.
5 Return to Step 4 of the main procedure.
Each branch procedure is self-contained and begins with Step 1. Be sure to
complete all of the steps in a branch procedure before you return to the main
procedure.
The examples in the following text refer to Steps 1 through 5 of the
Procedure (above), which is a branch of the Network Services procedure.
When you are to repeat a step within the branch procedure , you are instructed to
go to that step. For example, at Step 4 of the branch procedure you would go
back to Step 1 of the branch procedure and repeat branch Steps 1 through 4 for
additional toll services. If you did not need to enter any other toll services, you
would continue with Step 5 of the branch procedure.
When a branch step instructs you to return to the main procedure, the branch
procedure is complete. At Step 5 of the branch procedure you would return to
Step 4 of the Network Services procedure to continue. In some cases, you can
-NEJ
select
are noted in specific programming procedures. In cases where completing the
branch procedure also completes the main procedure you will be instructed to
-NEJ
select
programming menu.
Single or Block Items
Branching is also used when you can select between programming a single item
or a block of items, such as a single line or a block of lines, as shown in sample
Step 5.
Console/Display Instructions
5 Specify the line(s).
_
_
_
_
6 Continue with this step when you complete the branch procedure.
Additional Information
#
( on the PC) to return to the menu where the branch began; these
#
( on the PC) one or more times to return to the system
Additional Information
NN
xx = number entered in Step 2
_
To select a single line, go to
l
Single Line Procedure.
To select a block of lines, go to
u
Block of Lines Procedure.
l
AT&T Toll
l l u u
Programming Basics
PC
PC
1–17