AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 528

PRI Facilities
Terminal Equipment Identifier
Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
!
CAUTION:
The value of the TEI rarely has to be changed. Check with your AT&T
representative before changing this value.
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Terminal Equipment Identifier
Console Display/Instructions
1 Select the Lines and Trunks menu.
_
4–156
Programming Procedures
System manager
All
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
0
0 to 63
No
No
LinesTrunks PRI Protocol
Enter
Drop Dial new ID no.
Exit
Type new ID no.
Additional Information
TEI
Dial slot no. ® ®
Enter Exit
Type slot no.
Exit
2
+
PC