AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 636

Remote Access Features
Remote Access Trunk Assignment
Use this procedure to assign or remove the trunks used for remote access. You
can also use this procedure to specify whether the Remote Access feature is
dedicated (always used for remote access) or shared (used for remote access
only when Night Service is activated).
Trunks used for dedicated remote access must not be assigned to ring into a
calling group or the QCC queue (Hybrid/PBX mode only).
In Hybrid/PBX mode, if a trunk assigned to ring into the QCC queue is also used
for shared remote access, perform the procedure below before you perform the
"QCC Operator to Receive Calls" procedure.
NOTE:
A loop start line/trunk must be programmed for Reliable Disconnect if it is to be
used for remote access (see "Disconnect Signaling Reliablility").
Summary: Remote Access Trunk Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
4–264
Programming Procedures
System manager
All
Not required
Form 3a, Incoming Trunks: Remote Access
Remote Access is not assigned
Dedicated, Shared, No Remote
Yes
No
line/trunk no.
Type line/trunk no.
trunk is used
Dial
Specify how trunk is used
Specify how