AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 685

Night Service
NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night Service the
current day of the week for Night Service must be set using the following
procedure.
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
NOTE:
The current day of the week for Night Service must be reset if system
programming information is being loaded into memory from a backup.
Summary: Night Service with Time Set
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To add or change start/stop time:
PC Procedure
Dial the current day of the week
Dial
System manager
All
Not required
Form 9c, Night Service: Time Set
Not applicable
Day: 0 to 6; Time: 0000 to 2359
No
No
Drop
To activate/deactivate:
2
To add or change start/stop time:
2
+
+ Type stop day and time
To activate/deactivate:
or
Drop Dial start day and time
Dial stop day and time
or
Type start day and time
Programming Procedures
4–313