AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 436

Lines and Trunks
4. If you are copying assignments to a block of lines/trunks and one of the lines
or trunks is in use, you see the message
display. The copying for the rest of the lines/trunks in the block is delayed until
the busy line/trunk becomes idle. If you exit without waiting for the copying to
complete, the copying done up to that point is not canceled.
Summary: Copy Options for Lines/Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To copy individual lines/trunks:
PC Procedure
4–64
Programming Procedures
System manager
All (but note differences)
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Form 3c, Incoming Trunks: TIE
Form 3d, Incoming Trunks: DID
Not applicable
Not applicable
No
Not applicable
Dial copy to trunk no.
To copy blocks of lines/trunks:
Dial first copy to trunk no. in block
last copy to trunk no. in block
To copy individual lines/trunks:
Type copy to trunk no.
copy from trunk no.
To copy blocks of lines/trunks:
Type copy from trunk no.
copy to trunk no. in block
trunk no. in block
on your
Dial copy from trunk no.
Dial copy from trunk no.
Dial
Type
Type first
Type last copy to