AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 161

System Operator Positions
Console Display/Instructions
3 Select Direct-Line Console (DLC).
_
4 Specify the DLC extension.
5 Assign or remove the DLC operator extension.
Select or
.
6 Indicate that you have finished entering all positions.
Select .
Additional Information
If you get the System Busy message, wait
for an idle condition or exit system
programming and try again later.
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = extension is currently assigned
as a DLC position.
Flashing = extension can be assigned
as a DLC position.
Off = extension cannot be assigned
as a DLC position.
You may continue to assign or remove
DLC operator positions by repeating
Steps 4 and 5.
The session is terminated, and the system
restarts. You must enter system
programming again to continue.
Common Administrative Procedures
PC
Û
3–25