AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 566

Telephones
Console Procedure To program a single line/trunk:
PC Procedure
Copy Line/Trunk Assignments
Use this procedure to copy outside line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and (for operator positions only) Night
Service information from one extension to another extension or block of
extensions with identical requirements.
If you are copying assignments to a block of extensions and one of the
extensions in the block is in use, the display shows the
message. Copying for the rest of the extensions in the block is delayed until
the busy extension becomes idle. The number of the busy extension is not
shown. If a DSS is attached, the LED associated with the busy extension is on. If
you exit instead of waiting for the busy extension to become idle, copying for the
rest of the extensions is canceled; however, the assignments that have already
been copied are not canceled.
If you are copying assignments from an operator position to a block of
extensions that includes both operator and nonoperator extensions, the
information is copied only to the operator positions; the nonoperator positions
are not affected. Similarly, if you are copying assignments from a nonoperator
position to a block of extensions that includes both operator and nonoperator
extensions, the information is copied only to the nonoperator positions; the
operator positions are not affected. The system does not provide an error tone to
signal that the copy did not work for all of the extensions in the block.
Summary: Copy Line/Trunk Assignments
Programmable by
Mode
Idle Condition
4–194
Programming Procedures
E
Dial line/trunk no.
To program a block of lines/trunks:
Select trunk range Toggle LED On/Off
To program a single line/trunk:
Type ext. no.
To program a block of lines/trunks:
Type ext. no.
Toggle0 letter On/Off
System manager
All
Telephone idle
Dial ext. no.
Dial ext. no.
Type line/trunk no.
Select trunk range