Defining Acl Binding - Dell PowerConnect 3524P User Manual

Configuring MAC Based ACLs with CLI Commands
The following table summarizes the equivalent CLI commands for configuring MAC Based ACLs.
Table 7-6. MAC Based ACL CLI Commands
CLI Command
mac access-list access-list-name
no mac access-list access-list-name
permit {any|{source source- wildcard} {any|{
destination destination- wildcard}} [vlan vlan-id] [cos
cos cos-wildcard] [ethtype eth-type] [inner-vlan vlan-id]
deny [disable-port] {any|{source source- wildcard} {any|{
destination destination- wildcard}} [vlan vlan-id] [cos cos
cos-wildcard] [ethtype eth-type] [inner-vlan vlan-id]

Defining ACL Binding

When an ACL is bound to an interface, all the ACE rules that have been defined are applied to the
selected interface.Whenever an ACL is assigned on a port, LAG or, VLAN, flows from that ingress
interface that do not match the ACL are matched to the default rule, which is Drop unmatched packets.
To bind ACLs to interfaces:
1 Open the Network Security - ACL Bindings page, click Switch → Network Security → ACL Bindings.
Figure 7-13. Network Security - ACL Binding
2 In the Select an ACL field, select an IP Based or MAC Based ACL.
286
Configuring Switch Information
Description
To define a Layer 2 access list and to place the device in
MAC access list configuration mode, use the mac
access-list command in global configuration mode. To
remove the access list, use the no form of this command.
To set permit conditions for an MAC access list,
use the permit command in MAC access list
configuration mode.
To set deny conditions for an MAC access list, use the
deny command in MAC access list configuration mode.