Dell PowerConnect 3524P User Manual page 361

Displaying the VLAN LAG Table
1 Open the VLAN LAG Settings page.
2 Click Show All.
The VLAN LAG Table opens.
Figure 7-51. VLAN LAG Table
3 To change LAG settings, modify the fields for any LAGs in the table.
4 Click Apply Changes.
The VLAN LAG parameters are defined, and the device is updated.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN groups as
displayed in the VLAN LAG Settings page.
Table 7-28. LAG VLAN Assignments CLI Commands
CLI Command
switchport mode {access | trunk | general
switchport trunk native vlan vlan-id
switchport general pvid vlan-id
switchport general allowed vlan add vlan-list
tagged untagged
[ | ]
switchport general acceptable-frame-type
tagged-only
switchport access vlan dynamic
switchport general ingress-filtering disable
Description
} Configures a LAG VLAN membership mode.
Defines the port as a member of the specified VLAN, and the
VLAN ID as the LAG default VLAN ID (PVID).
Configure the LAG VLAN ID (PVID) when the interface is in
general mode.
Adds or removes VLANs from a general LAG.
Discards untagged packets at ingress.
Binds the MAC address to the VLAN.
Disables LAG ingress filtering.
Configuring Switch Information
361