Dell PowerConnect 3524P User Manual page 153

Viewing IPv6 Routes Table Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6
Routes Table page.
Table 6-26. IPv6 Default Gateway CLI Commands
CLI Command
traceroute {ipv4-address | hostname} [
max-ttl] [count packet_count] [timeout time_out] [source
ip-address] [tos tos]
traceroute ipv6 {ipv6-address | hostname} [size packet_size]
[ttl max-ttl] [count packet_count] [timeout time_out]
[source ip-address] [tos tos]
show ipv6 route
The following is an example of the CLI commands:
Console> show ipv6 route
Codes: L - Local, S - Static, I - ICMP, ND - Router Advertisment
The number in the brackets is the metric.
S ::/0 via fe80::77 [0] VLAN 1 Lifetime Infinite
ND ::/0 via fe80::200:cff:fe4a:dfa8 [0] VLAN 1 Lifetime 1784 sec
L 2001::/64 is directly connected, g2 Lifetime Infinite
L 2002:1:1:1::/64 is directly connected, VLAN 1 Lifetime 2147467 sec
L 3001::/64 is directly connected, VLAN 1 Lifetime Infinite
L 4004::/64 is directly connected, VLAN 1 Lifetime Infinite
L 6001::/64 is directly connected, g2 Lifetime Infinite
Description
size ttl
packet_size] [ Discovers the routes that IPv4 packets will
actually take when traveling to their destination.
Discovers the routes that IPv6 packets will
actually take when traveling to their destination.
Displays the current state of the ipv6 routing
table.
Configuring System Information
153