Dell PowerConnect 3524P User Manual page 237

Deleting Communities
1 Open the SNMP Community page.
2 Click Show All.
The Community Table page opens.
Figure 6-99. Community Table
3 Select a community and check the Remove check box.
4 Click Apply Changes.
The community entry is deleted, and the device is updated.
Configuring Communities Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the SNMP
Community.
Table 6-50. SNMP Community CLI Commands
CLI Command
snmp-server community community [ro | rw |
su] [ipv4-address | ipv6-address][view view-
name]
snmp-server community-group community
group-name [ipv4-address | ipv6-address]
show snmp
The following is an example of the CLI commands:
Console (config)# snmp-server community dell ro 10.1.1.1
Description
Sets up the community access string to permit access to the
SNMP protocol.
Sets up community access string to permit limited access to the
SNMP protocol based on group access rights.
Displays the current SNMP device configuration.
Configuring System Information
237