Defining Port Mirroring Sessions
Port mirroring does the following:
•
Monitors and mirrors network traffic by forwarding copies of incoming and outgoing packets from one
port to a monitoring port.
•
Can be used as a diagnostic tool and/or a debugging feature.
•
Enables device performance and monitoring.
Port mirroring is configured by selecting a specific port to copy all packets, and different ports from
which the packets are copied.
Before configuring Port Mirroring, note the following:
•
Port mirroring monitors and mirrors network traffic by forwarding copies of incoming and outgoing
packets, from a monitored port to a monitoring port.
•
Monitored port cannot operate faster than the monitoring port.
•
All the RX/TX packets should be monitored to the same port.
The following restrictions apply to ports configured to be destination ports:
•
Ports cannot be configured as a source port.
•
Ports cannot be a LAG member.
•
IP interfaces are not configured on the port.
•
GVRP is not enabled on the port.
•
The port is not a VLAN member.
•
Only one destination port can be defined.
The following restrictions apply to ports configured to be source ports:
•
Source Ports cannot be a LAG member.
•
Ports cannot be configured as a destination port.
•
Mirroring supports 4 ports in this device.
312
Configuring Switch Information