Dell PowerConnect 3524P User Manual page 146

To open the IPv6 ISATAP Tunnel page, click System
tree view.
Figure 6-38. IPv6 ISATAP Tunnel
• ISATAP Status — Specifies the status of ISATAP on the device. The possible field values are:
– Enable — ISATAP is enabled on the device.
– Disable — ISATAP is disabled on the device. This is the default value.
• IPv4 Address — Specifies the local (source) IPv4 address of a tunnel interface.
• Tunnel Router's Domain Name — Specifies a global string that represents a specific automatic tunnel
router domain name. The default value is ISATAP.
– Use Default — Selecting the check box returns settings to default.
• Domain Name Query Interval — Specifies the interval between DNS Queries (before the IP address
of the ISATAP router is known) for the automatic tunnel router domain name. The range is
10 - 3600 seconds. The default is 10 seconds.
– Use Default — Selecting the check box returns settings to default.
• ISATAP Router Solicitation Interval — Specifies the interval between router solicitations messages
when there is no active router. The range is 10 - 3600 seconds. The default is 10.
– Use Default — Selecting the check box returns settings to default.
• ISATAP Robustness — Specifies the number of DNS Query/ Router Solicitation refresh messages that
the device sends. The range is 1 - 20 seconds. The default is 3.
– Use Default — Selecting the check box returns settings to default.
146
Configuring System Information
→ →
IP Addressing IPv6 ISATAP Tunnel in the