The File Upload to Server page contains the following fields:
•
Supported IP Format — Specifies the IP format supported by the server. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.
•
IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
–
Global — A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
–
ISATAP — The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Upload — The Firmware file is uploaded. If Firmware Upload is selected, the
Configuration Upload fields become unavailable.
•
Configuration Upload — The Configuration file is uploaded. If Configuration Upload is selected,
the Software Image Upload fields become unavailable.
•
Upload via TFTP — Enables initiating an image upload via the TFTP server.
•
Upload via HTTP — Enables initiating an image upload via the FTP server.
Software Image Upload
•
TFTP Server IP Address — The TFTP Server IP Address to which the Software Image is uploaded.
•
Destination File Name (1-64 Characters) — Indicates the Software Image file path to which the file is
uploaded.
Configuring System Information
251