Dell PowerConnect 3524P User Manual page 202

• Dead Time (0-2000) — Indicates the amount of time (in minutes) that a RADIUS server is bypassed
for service requests. The range is 0-2000.
• Key String (0-128 Characters) — The Key string used for authenticating and encrypting all RADIUS
communications between the device and the RADIUS server. This key is encrypted.
• Source IP Address — Indicates the source IP address that is used for communication with RADIUS
servers.
• Usage Type — Indicates the server usage type. Can be one of the following values: login, 802.1x or
all. If unspecified, defaults to all.
• Use Default — Uses the default value for the parameter.
If host-specific Timeouts, Retries, or Dead time values are not specified, the Global values (Defaults) are
applied to each host. The following fields set the RADIUS default values:
• Default Retries (1-10) — Indicates the default number of transmitted requests sent to RADIUS server
before a failure occurs.
• Default Timeout for Reply (1-30) — Indicates the default amount of the time (in seconds) the device
waits for an answer from the RADIUS server before timing out. The default is 5 seconds.
• Default Dead time (0-2000) — Indicates the default amount of time (in minutes) that a RADIUS
server is bypassed for service requests. The range is 0-2000.
• Default Key String (0-128 Characters) — The Default Key string used for authenticating and
encrypting all RADIUS communications between the device and the RADIUS server. This key
is encrypted.
• Source IPv4 Address — Specifies the source IP version 4 address that is used for communication with
RADIUS servers.
• Source IPv6 Address — Specifies the source IP version 6 address that is used for communication with
RADIUS servers.
When adding a new RADIUS server, the following additional parameter is available:
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
– IPv6 Global — IP version 6 is supported.
– IPv4 — IP version 4 is supported.
Defining RADIUS Parameters:
1 Open the RADIUS Settings page.
2 Define the fields.
3 Click Apply Changes.
The RADIUS setting are updated to the device.
202
Configuring System Information