Dell PowerConnect 3524P User Manual page 141

Defining IPv6 Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6
Interface page.
Table 6-22. IPv6 Interface CLI Commands
CLI Command
ipv6 enable [no-autoconfig]
ipv6 address autoconfig
ipv6 icmp error-interval milliseconds [bucket-
size]
show ipv6 icmp error-interval
ipv6 address ipv6-address/prefix-length [eui-64]
[anycast]
ipv6 address ipv6-address link-local
ipv6 unreachables
show ipv6 interface [ethernet interface-number
| vlan vlan-id | port-channel number]
ipv6 nd dad attempts attempts-number
ipv6 host name ipv6-address1 [ipv6-
address2...ipv6-address4]
ipv6 set mtu {ethernet interface | port-channel
port-channel-number} { bytes | default}
ping {ipv4-address | hostname} [size
packet_size] [count packet_count] [timeout
time_out]
ping ipv6 {ipv6-address | hostname} [size
packet_size] [count packet_count] [timeout
time_out]
Description
Enables IPv6 processing on an interface.
Enables automatic configuration of IPv6 addresses using
stateless auto-configuration on an interface.
Configures the rate limit interval and bucket size parameters
for IPv6 Internet Control Message Protocol (ICMP) error
messages.
Displays the ipv6 icmp error interval.
Configures an IPv6 address for an interface.
Configures an IPv6 link-local address for an interface.
Enables the generation of Internet Control Message Protocol
for IPv6 (ICMPv6) unreachable messages for any packets
arriving on a specified interface.
Displays the usability status of interfaces configured for IPv6.
Configures the number of consecutive neighbor solicitation
messages that are sent on an interface while duplicate address
detection is performed on the unicast IPv6 addresses of the
interface.
Defines a static host name-to-address mapping in the host
name cache.
Sets the maximum transmission unit (MTU) size of IPv6
packets sent on an interface.
Sends IPv4 ICMP echo request packets to another node on
the network.
Sends IPv6 ICMP echo request packets to another node on
the network.
Configuring System Information
141