Configuring Lldp Using Cli Commands; Defining Lldp Port Settings - Dell PowerConnect 3524P User Manual

Configuring LLDP Using CLI Commands

Table 6-43. LLDP Properties CLI Commands
CLI Command
lldp enable (global)
lldp hold-multiplier
number
lldp reinit-delay Seconds Specifies the minimum time an LLDP port will wait
lldp tx-delay
The following is an example of the CLI commands:
Console(config)# interface ethernet g1
Console(config-if)# lldp enable

Defining LLDP Port Settings

The LLDP Port Settings page allows network administrators to define LLDP port settings, including the
port number, the LLDP port number, and the type of port information advertised.
The Port Settings page contains fields for configuring LLDP . To open the Port Settings page,
→
click System LLDP-MED
208
Configuring System Information
Description
Enables enable Link Layer Discovery Protocol.
Specifies the time that the receiving device should
hold a Link Layer Discovery Protocol (LLDP) packet
before discarding it.
before reinitializing.
Specifies the delay between successive LLDP frame
Seconds
tr.ansmissions.
→
Port Settings in the tree view.