Defining Acl Binding - Dell PowerConnect 54 Series User Manual

Configuring MAC Based ACLs with CLI Commands
The following table summarizes the equivalent CLI commands for configuring MAC Based ACLs .
Table 7-6. MAC Based ACL CLI Commands
CLI Command
mac access-list access-list-name
no mac access-list access-list-name
permit {any|{source source- wildcard} {any|{ destination
destination- wildcard}} [vlan vlan-id] [cos cos cos-wildcard]
[ethtype eth-type] [inner-vlan vlan-id]
deny [disable-port] {any|{source source- wildcard} {any|{
destination destination- wildcard}} [vlan vlan-id] [cos cos cos-
wildcard] [ethtype eth-type] [inner-vlan vlan-id]

Defining ACL Binding

When an ACL is bound to an interface, all the ACE rules that have been defined are applied to the selected
interface.Whenever an ACL is assigned on a port or LAG, flows from that ingress interface that do not
match the ACL are matched to the default rule, which is Drop unmatched packets.
Description
To define a Layer 2 access list and to place the device
in MAC access list configuration mode, use the mac
access-list command in global configuration mode.
To remove the access list, use the no form of this
command.
To set permit conditions for an MAC access list, use
the permit command in MAC access list
configuration mode.
To set deny conditions for an MAC access list, use the
deny command in MAC access list configuration
mode.
Configuring Device Information
237