Dell PowerConnect 3524P User Manual page 248

The File Download from Server page contains the following fields:
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
– IPv6 — IP version 6 is supported.
– IPv4 — IP version 4 is supported.
• IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
– Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
– Global — A globally unique IPv6 address; visible and reachable from different subnets.
• Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
– VLAN1 — The IPv6 interface is configured on VLAN1.
– ISATAP — The IPv6 interface is configured on ISATAP tunnel.
• Firmware Download — The Firmware file is downloaded. If Firmware Download is selected,
the Configuration Download fields are grayed out.
• Configuration Download — The Configuration file is downloaded. If Configuration Download is
selected, the Firmware Download fields are grayed out.
• Download via TFTP — Enables initiating an image upload via the TFTP server.
• Download via HTTP — Enables initiating an image upload via the HTTP server.
Firmware Download
• Server IP Address — The Server IP Address from which the firmware files are downloaded.
• Source File Name (1-64 characters) — Indicates the file to be downloaded.
• Destination File Name — The destination file type to which the file is downloaded. The possible field
values are:
– Software Image — Downloads the Image file. The image file overwrites the non-active image. It is
recommended to designate that the non-active image becomes the active image after reset, and
then to reset the device following the download. During the Image file download a dialog box
opens which displays the download progress. The window closes automatically when the download
is complete.
– Boot Code — Downloads the Boot file.
248
Configuring System Information