Dell PowerConnect 3524P User Manual page 222

Enabling SNMP Notifications Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the SNMP
Global Parameters page.
Table 6-46. SNMP Notification Commands
CLI Command
snmp-server enable
traps
snmp-server trap
authentication
show snmp
snmp-server engine ID
local {engineid-string |
default}
The following is an example of the CLI commands:
Console(config)# snmp-server enable traps
Console(config)# snmp-server trap authentication
Console# show snmp
Community-String Community-Access
---------------- -----------------
public
Community-String Group name
---------------- ----------
Traps are enabled.
Authentication-failure trap is enabled.
222
Configuring System Information
Description
Enables the router to send Simple Network Management Protocol traps
Enables the router to send Simple Network Management Protocol traps
when authentication fails
Checks the status of SNMP communications.
Indicates the local device engine ID. The field values is a hexadecimal
string. Each byte in hexadecimal character strings is two hexadecimal
digits. Each byte can be separated by a period or colon. The Engine ID
must be defined before SNMPv3 is enabled.
read only
View name IP address
--------- ----------
view-1 All
IP address Type
----------
----