Dell PowerConnect 3524P User Manual page 447

• Interface — Indicates the port or LAG that is being displayed.
• Egress Shaping Rate on Selected Port — Indicates the Egress traffic limit status for the interface.
– Checked — The Egress traffic limit is enabled.
– Not Checked — The Egress traffic limit is disabled.
• Committed Information Rate (CIR) — Defines the Egress CIR traffic limit for the interface.
• Ingress Rate Limit Status — Indicates the Ingress traffic limit status for the interface.
– Checked — The Ingress traffic limit is enabled.
Not Checked — The Ingress traffic limit is disabled.
–
• Ingress Rate Limit — Defines the Ingress traffic limit for the interface.
Assigning bandwidth settings for an interface:
1 Open the Bandwidth Settings page.
2 Select an interface in the Interface field.
3 Define the fields.
4 Click Apply Changes.
The bandwidth settings are assigned to the interface.
Displaying the Bandwidth Settings Table:
1 Open the Bandwidth Settings page.
2 Click Show All.
The Bandwidth Settings Table opens.
Figure 9-4. Bandwidth Settings Table
Configuring Quality of Service
447