Dell PowerConnect 3524P User Manual page 48

3 Set the data rate to 9600 baud.
4 Set the data format to 8 data bits, 1 stop bit, and no parity.
5 Set flow control to none.
6 Under Properties, select VT100 for Emulation mode.
7 Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the setting is for Terminal keys
(not Windows keys).
CAUTION:
When using HyperTerminal with Microsoft
Pack 2 or later installed. With Windows 2000 Service Pack 2, the arrow keys function properly in HyperTerminal's
VT100 emulation. Go to www.microsoft.com for information on Windows 2000 service packs.
8 Connect the female connector of the RS-232 crossover cable directly to the device Console port on the
Master unit/stand-alone device, and tighten the captive retaining screws. The PowerConnect 35xx
Series Systems Console port is on the rear panel.
Figure 3-7. Connecting to PowerConnect 35xx Series Systems Console Port
NOTE:
A console can be connected to the Console port on any unit in the stack, but stack management is
performed only from the stack master (unit ID 1 or 2).
48
Installing the PowerConnect 3524/P and PowerConnect 3548/P
®
Windows
To VT100
Terminal
®
2000,ensure that you have Windows 2000 Service
Back Panel