Dell PowerConnect 3524P User Manual page 311

4 Check the Copy to check box to define the interfaces to which the storm control definitions are
copied, or click Select All to copy the definitions to all ports.
5 Click Apply Changes.
The parameters are copied to the selected ports in the Storm Control Settings Table, and the device is
updated.
Configuring Storm Control with CLI Commands
The following table summarizes the equivalent CLI commands for configuring Storm Control as
displayed on the Storm Control page.
Table 7-14. Storm Control CLI Commands
CLI Command
port storm-control include-multicast
port storm-control broadcast enable
port storm-control broadcast rate
show ports storm-control
The following is an example of the CLI commands:
console(config)# port storm-control include-multicast
console(config)# interface ethernet 1/e1
console(config-if)# port storm-control broadcast enable
console(config-if)# port storm-control broadcast rate 100000
console(config-if)# end
console# show ports storm-control
Port
-----
1/e1
2/e1
3/e2
Description
Enables the device to count Multicast,
Unicast, and Broadcast packets together.
Enables broadcast storm control.
Configures the maximum broadcast rate.
Displays the storm control configuration.
port
Broadcast Storm control [kbyes/sec]
-------------------------------------
8000
Disabled
Disabled
Configuring Switch Information
311