Dell PowerConnect 3524P User Manual page 51

• Device IP address
• Default Gateway IP address
The following is displayed:
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch configuration,
and gets you up and running as quickly as possible. You can skip the
setup wizard, and enter CLI mode to manually configure the switch.
The system will prompt you with a default answer; by pressing enter,
you accept the default.
You must respond to the next question to run the setup wizard within
60 seconds, otherwise the system will continue with normal operation
using the default system configuration.
Would you like to enter the Setup Wizard (you must answer this
question within 60 seconds? (Y/N)[Y]Y
You can exit the Setup Wizard at any time by entering [ctrl+Z].
If you enter [N], the Setup Wizard exits. If there is no response within 60 seconds, the Setup Wizard
automatically exits and the CLI console prompt appears.
If you enter [Y], the Setup Wizard provides interactive guidance through the initial device configuration.
NOTE:
If there is no response within 60 seconds, and there is a BootP server on the network, an address is
retrieved from the BootP server.
NOTE:
You can exit the Setup Wizard at any time by entering [ctrl+z].
Wizard Step 1
The following is displayed:
The system is not setup for SNMP management by default.
To manage the switch using SNMP (required for Dell Network Manager)
you can
•
Setup the initial SNMP version 2 account now.
•
Return later and setup additional SNMP v1/v3 accounts.
For more information on setting up SNMP accounts, please see the user
documentation.
Would you like to setup the SNMP management interface now? (Y/N)[Y]Y
Enter [N] to skip to Step 2.
Configuring PowerConnect 3524/P and 3548/P
51