Assigning QoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the Interface
Settings page.
Table 9-4. QoS Interface CLI Commands
CLI Command
qos trust
no qos trust
The following is an example of the CLI commands:
console(config)# interface ethernet 1/e15
console(config-if)# qos trust
Defining Bandwidth Settings
The Bandwidth Settings page contains fields for defining the bandwidth settings for a specified egress
interface. Modifying queue scheduling affects the queue settings globally. Queue shaping can be based
per queue and/or per interface. Shaping is determined by the lower specified value. The queue shaping
type is selected in the Bandwidth Settings Page, click Quality of Service → CoS Global Parameters→
Bandwidth Settings in the tree view.
Figure 9-3. Bandwidth Settings
446
Configuring Quality of Service
Description
Enables the trust mode.
Disables Trust state on each port.