Installing And Removing Memory; Install So-Dimms - Intel NUC DN2820FYKH User Manual

Intel NUC Kit DN2820FYKH User Guide
2. Lift up the hard drive bracket and set it over the edge of the chassis to expose the motherboard.

Installing and Removing Memory

Intel NUC Kit DN2820FYKH has one 204-pin DDR3L SO-DIMM socket. Memory requirements:
 1.35V low voltage memory
 1066 MHz SO-DIMM on the Intel Celeron processor N2820
 1333 MHz SO-DIMM on the Intel Celeron processor N2830
 Non-ECC
For a list of tested memory, go to the

Install SO-DIMMs

To install a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
4
System Memory page on the Support site.