Enable; Errorlog - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
•
info events:
•
liveness-failure
•
process-exit
•
cpu-util-ok
•
cpu-util-high
•
disk-space-ok
•
disk-space-low
show email
Email notification settings. This does not include SNMP traps, which are under the snmp-
server command tree.

enable

Enter Enable mode.
enable
From enable enter configure terminal to go to Configuration mode. Use disable to go from
Enable mode back to Standard mode.

errorlog

Configure error log options. See
"Configuring Media Flow Controller Service Logs (CLI)" on page 226
information on log rotation.
Note! This log is mainly used for debugging purposes by Juniper Networks Support.
errorlog
copy <SCP>
filename <name>
level {1 | 2 | 3 | 4 | 5-7}
module <module>
on-the-hour {disable | enable}
rotate {filesize-MB <integer> | time-interval <hours>}
syslog replicate {disable | enable}
Notes:
•
—Auto upload (when the set rotate criteria is reached) the errorlog using SCP
copy
(secure channel protocol), to the server specified using hostname. If username and
password are provided, Media Flow Controller uses that for authentication of the SCP
session. The no variant disallows auto upload. See
URL format); you must have an SCP server installed in order to SCP, files to your
machine.
•
filename
errorlog.<num>.yyyymmdd_hour:min:sec (numbered sequentially).
—A process in the system was detected as hung.
—A process in the system unexpectedly exited.
—CPU utilization has fallen back to normal levels.
—CPU utilization has risen too high.
—File system free space is back in the normal range.
—File system free space has fallen too low.
"Error Log (errorlog)" on page 215
—Configure the name of the file where the error log is stored. Default is
Media Flow Controller CLI Commands
for usage information. See
for task details including
"Terminology" on page 30 for the scp
enable 313