Configuring The Web Interface (Web Interface) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)
Reboot or Shutdown
Rebooting the system brings up the last active configuration. See
To reboot or shutdown the system:
1. Click Reboot to bring up the last active configuration.
2. Click Shutdown to turn the system off.

Configuring the Web Interface (Web Interface)

Before you configure the Media Flow Controller Web interface, see
Media Flow Controller" on page
Configure Media Flow Controller Web interface options.
To configure the Web interface Management Console:
•
From the left navigation pane in the System Config tab, select Web Mgmt.
The Web Settings page is displayed. See
To set parameters for the Media Flow Controller Web interface:
1. Enter this information to the text boxes:
• Enable Web Configuration—Allow configurations via the Web interface.
• Auto Logout Timeout—Control the length of user inactivity required before the Web
interface automatically logs out a user.
• Enable HTTP and set an HTTP Port, de-select to disable HTTP.
• Enable HTTPS and set an HTTPS Port, de-select to disable HTTPS.
• Web Session Renewal—Control the length of time before Web session cookies are
automatically regenerated.
• Web Session Timeout—Configure time after which a session expires.
2. Click Apply to complete operation; Cancel to revert to existing configuration. You can also
Generate New HTTPS Certificate by clicking that button.
3. Click Save at the top of the page to make changes persistent across reboots.
158 Configuring the Web Interface (Web Interface)
Media Flow Controller Administrator's Guide
58.
Figure 38.
Figure 37.
"Before You Configure
Copyright © 2010, Juniper Networks, Inc.