Cmc Rendezvous - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller CLI Commands
•
•
•
•
capabilities username
execute proxied requests from the CMC server when there is a client-initiated
connection.
disabled, this setting is reset to admin and the CMC client functionality is disabled
overall. This latter change may be disruptive, but its intention is to prevent an
unintended increase in the capabilities of the server through proxied requests.
•
port <port number>
initiated connections. The no variant resets the port to its default, 22.
•
remove-key
the currently configured server. This should only be necessary if the server's host key
changes.
•
source
connections.
•
•
•
show cmc client
List miscellaneous information about a CMC client.

cmc rendezvous

Configure Central Management Console rendezvous options.
cmc rendezvous
client
auth default
auto
force
server-addr
service-name <name>
302 cmc rendezvous
—Configure the type of authentication to be used. The no variant
authtype
resets the authtype to its default, which is none.
password password <password>
username for password-based authentication. If password password is set
without a <password>, the user is prompted for the password.
or ssh-rsa2 identity and username —Set the identity and
ssh-dsa2
username for ssh-dsa2-based or ssh-rsa2-based authentication.
Note! If the user specified with this command is subsequently deleted or
—Set the port of the CMC server to connect to, for client-
—Remove any known host entry Media Flow Controller already has for
—Configure validation of server address and source port for server-initiated
—Set the IP address of the server from which Media Flow Controller
address
expects to receive server-initiated connections. If not set (or cleared with no), the
main server address set with cmc client server address is used instead.
port <port number>
Controller expects to receive server-initiated connections. If not set (or cleared
with no), the source port is be verified.
—Specifies whether or not Media Flow Controller should check the
validate
originating IP address and port of the server against those specified in the
configuration (the main server address or the source address and port). If set and
there is not a match with whatever logs into Media Flow Controller for CMC
management, break the connection.
Media Flow Controller Administrator's Guide
or username <name> —Set the password or
—Set the username whose credentials should be used to
—Set the source port on the server from which Media Flow
Copyright © 2010, Juniper Networks, Inc.