Configuring Delivery Protocols (Web Interface) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)
bandwidth setting. Default is 0 (zero), means Media Flow Controller best effort. AFR
is disabled by default; if needed, you can enable it with these configurations or with a
virtual-player configuration.
2. Click Apply.
3. Click Save at the top of the page to make changes persistent across reboots.

Configuring Delivery Protocols (Web Interface)

Set delivery options, including listen interfaces for traffic, for delivering content to the player
(end-user/consumer). If not specified, default actions take place in the delivery path.
This command sets global attributes; use
basis.
To configure the HTTP delivery protocol:
•
From the left navigation pane in the Service Config tab, select Delivery Protocol.
The Delivery Protocol Configuration page is displayed. See
164 Configuring Delivery Protocols (Web Interface)
Media Flow Controller Administrator's Guide
namespace to set these attributes on a namespace
Copyright © 2010, Juniper Networks, Inc.
Figure 43.