Stats - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller CLI Commands
show ssh server [host-keys]
SSH server information, including whether or not it is enabled, and the host key fingerprints.
Use the host-keys option to list information about the SSH server, including whether or not it
is enabled, the host key fingerprints, and the full host keys.

stats

Configure statistics and alarms. To see default threshold values, enter show stats alarm
<alarm_ID>. Set email notifications for these stats using
Log Statistics Thresholds (CLI)" on page 231
stats
alarm <alarm_ID>
clear
enable
falling [clear-threshold <value>] [error-threshold <value>]
rate-limit
rising [clear-threshold <value>] [error-threshold <value>]
chd <CHD_ID>
clear
compute time [interval <seconds>] [range <seconds>]
enable
clear-all
export {<format> | csv} {<report_name>| cpu_util | memory | paging}
after <date><time> [before <date><time>]
before <date><time> [after <date><time>]
filename <filename>
sample <sample_ID>
clear
enable
interval <number_of_seconds>
Notes:
•
alarm <alarm_ID>
"stats alarms,"
fall below a certain point, others when they rise above a certain point.
•
clear
clears the watermarks, and forgets the event history.
alarm = max value since reset; for falling alarm = min value since reset.
•
enable
•
falling
•
•
•
rate-limit
358 stats
count {long <count> | medium <count> | short <count>}
reset
window {long<duration> | medium<duration> | short<duration>}
after <date><time> [before <date><time>]
before <date><time> [after <date><time>]
—Configure alarms based on sampled or computed statistics. See
for the list of supported alarms. Some statistics are of concern when they
—Clear all state for this alarm. Clearing an alarm resets it to a nonerror state,
—Enable this alarm. Use no stats alarm <alarm_ID> enable to disable.
—Set alarm for when specified statistic fall too low.
clear-threshold <value>
error-threshold <value>
—Set alarm event rate-limits:
Media Flow Controller Administrator's Guide
email commands. See
for task details.
Note!
—This value terminates the alarm.
—This value initiates the alarm.
Copyright © 2010, Juniper Networks, Inc.
"Configuring
"watermark" for rising