Fmsedgelog - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller CLI Commands
URL format); you must have an SCP server installed in order to SCP files to your
machine.
•
filename
fmsaccesslog.<num>.yyyymmdd_hour:min:sec (numbered sequentially).
•
on-the-hour
•
rotate
•
filesize-MB
"fmsaccess.log.1," "fmsaccess.log.2" and so on up to "fmsaccess.log.10," after which
it wraps around. By default, each file size is 100MB. We highly recommend not
increasing the size; huge file transfers take a lot of time, and if there is a system reset,
large volumes of data are at risk.
•
time-interval
FMS access log is rotated.
•
syslog replicate
seen as part of SYSLOG; default is no (disabled); FMS access log is not in SYSLOG.

fmsedgelog

Configure FMS (Flash Media Server) edge log options; this log is generated by the FMS
server. In the Web-based interface, this log is displayed as FMSEdge Log under the Logs
tab. The fmsedgelog lists transactions to the FMS edge server; for example, "Connection
rejected by server," "Edge disconnected from core," "Listener started for clients." This log is
written to /nkn/adobe/fms/logs/edge.<nn>.log, by default (you can access this using
application fms shell). This log is used for diagnostic purposes.
See "Configuring Media Flow Controller Service Logs (CLI)" on page 226
including information on log rotation. See
usage information.
fmsedgelog
copy <SCP>
filename <name>
on-the-hour {disable | enable}
rotate {filesize-MB <integer> | time-interval <hours>}
syslog replicate {disable | enable}
Notes:
•
—Auto upload (when the set rotate criteria is reached) the FMS edge log using SCP
copy
(secure channel protocol), to the server specified using hostname. If username and
password are provided, Media Flow Controller uses that for authentication of the SCP
session. The no variant disallows auto upload. See
URL format); you must have an SCP server installed in order to SCP files to your
machine.
•
filename
fmsedgelog.<num>.yyyymmdd_hour:min:sec (numbered sequentially).
•
on-the-hour
318 fmsedgelog
—Configure the name of the file where the FMS access log is stored. Default is
—Set hourly log rotation. Default is no (disabled).
—Media Flow Controller allows FMS access log rotation based on file size or time.
—Set rotation based on file size. Media Flow Controller creates
—Set rotation based on time. Specify a time in hours after which the
—Specify whether (enable) or not FMS access log messages are
—Configure the name of the file where the FMS edge log is stored. Default is
—Set hourly log rotation. Default is no (disabled).
Media Flow Controller Administrator's Guide
"FMSEdge Log (fmsedgelog)" on page 218
"Terminology" on page 30
Copyright © 2010, Juniper Networks, Inc.
for task details
for
for the scp