Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual page 323

Media Flow Controller Administrator's Guide
ip
Configure Internet protocol (IP) settings. See
DNS, and Default Gateway (CLI)" on page 61
ip
default-gateway {<next_hop_IP_address_or_Interface> [<interface>]}
dhcp
hostname <DHCP_hostname>
primary-intf <interface_name>
default-gateway yeild-to-static
send-hostname <DHCP_hostname>
domain-list <domain_name_for_resolving_hostnames> ...
filter
chain {FORWARD | INPUT | OUTPUT}
enable
host <hostname> <IP_address>
map-hostname
name-server <IP_address>
route <network_prefix> {<netmask> | <mask_length>} {<next_hop_IP_address>
| <interface>}
Notes:
•
default-gateway
•
—Dynamic Host Configuration Protocol settings. An interface is only eligible to be
dhcp
the DHCP primary if it is "admin up", has DHCP enabled, and has gotten a DHCP lease.
Ineligibility does not prevent an interface from being configured as the DHCP primary
interface, but prevents it from actually being used as such. If the configured primary is
eligible, it is chosen as the acting primary; otherwise, one of the eligible interfaces is
chosen (the first, in alphabetical order).
•
hostname <DHCP_hostname>
client to send to the server during DHCP negotiation. This only applies when ip dhcp
send-hostname has been enabled. The hostname may be unqualified or fully
qualified. This is a global configuration command that affects all DHCP interfaces.
Changing this setting forces a renewal of DHCP on all interfaces.
•
default-gateway yield-to-static
yields to a statically configured default gateway. Default is not to yield, so the DHCP
default gateway is added to the statically configured one. If yield-to-static is set,
DHCP's default gateway is not installed if there is already one statically configured.
•
primary-intf
specific configurations (resolver and routes) are accepted via DHCP.
•
send-hostname
server. By default, no hostname is sent during DHCP negotiation. The server may
use and honor the hostname supplied by the client. By default, the client sends the
system's hostname. This may be overridden with the command ip dhcp hostname
clear
policy {ACCEPT | DROP}
rule {move | append | insert | set | modify} target <target>
[<rule_arguments>]
—Set or delete (with no) the default route.
—Set or delete (with no) the interface from which non-interface-
—Configure whether the DHCP client should send a hostname to the
Media Flow Controller CLI Commands
"Configuring Interfaces, Hostname, Domain List,
for task details.
—Configure an alternate hostname for the DHCP
—Whether or not a DHCP default gateway
ip 323