Table of Contents
Advertisement
Media Flow Controller CLI Commands
•
level
messages. See
Note!
•
mod <module>
"errorlog module Options,"
•
on-the-hour
•
rotate
•
filesize-MB
"error.log.1," "error.log.2" and so on up to "error.log.10," after which it wraps around.
By default, each file size is 100MB. We highly recommend not increasing the size;
huge file transfers take a lot of time, and if there is a system reset, large volumes of
data are at risk.
•
time-interval
error log is rotated.
•
syslog replicate
part of SYSLOG; default is no (disabled), error log is not seen as part of SYSLOG.
errorlog level Options
The errorlog levels that can be set are shown in
Table 29
errorlog level Options
Level
1
2
3
4
5 - 7
errorlog module Options
The errorlog named and Hex code modules that can be set are shown in
Table 30
errorlog module Options
Module
all
analytics
http
media-cache
314
errorlog
—Set the errorlog severity level. Each higher number level setting includes more
"errorlog level Options,"
Severe messages are always sent regardless of chosen module.
—Set errorlog module; default is 0x00FFFFFFFFFFFFFF (Any). See
for details.
—Set hourly log rotation. Default is no (disabled).
—Media Flow Controller allows error log rotation based on file size or time.
—Set rotation based on file size. Media Flow Controller creates
—Set rotation based on time. Specify a time in hours after which the
—Specify whether (enable) or not error log messages are seen as
Severe: Function failed, subsystem failed, immediate attention required. Severe
messages are always sent regardless of chosen module.
Error: Function worked incorrectly.
Warning: Function worked, but not as expected.
Message: System activity.
Debug: Progressively more detailed messages.
All modules
The analytics module
The HTTP module
The media-cache module
Media Flow Controller Administrator's Guide
for details.
Table
29.
Description
Description
Copyright © 2010, Juniper Networks, Inc.
Table
30.
Advertisement
Chapters
Table of Contents
Troubleshooting
