Configuring Dns And Domain Names (Web Interface) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)
•
Interface—The port configured for this static route.
•
Active—Whether or not this route is being used currently.
•
Static—Whether or not this route is static (hard coded).
Select a route and click Removed Selected to immediately apply changes; click Save at the
top of the page to make them persistent across reboots.
Add Static Route
Static routes set a path in the routing table for a particular destination. See
To set a static route:
1. Enter this information to the text boxes:
• Destination—A network prefix for where you want a static route to.
• Netmask—The netmask for the configured network prefix.
• Gateway—IP address of the configured default gateway.
• Interface—Select a configured interface from the drop-down list.
2. Click Add Route to immediately apply changes.
3. Click Save at the top of the page to make them persistent across reboots. See

Configuring DNS and Domain Names (Web Interface)

View, add, modify, or remove Static and Dynamic Name Servers and Domain Names from
your Domain Name System (DNS).
To configured DNS and domain names:
•
From the left navigation pane in the System Config tab, select DNS.
The DNS page is displayed. See
124 Configuring Interfaces, Default Gateway, Static Routes, DNS and Domain Names, Hostname and Banners
Media Flow Controller Administrator's Guide
Figure 16.
Figure 15.
Figure 15.