Installing And Using Fms In Media Flow Controller (Cli); Installing Fms On Media Flow Controller (Cli) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide

Installing and Using FMS in Media Flow Controller (CLI)

Before you configure FMS in Media Flow Controller, see
Controller" on page
Media Flow Controller has the ability to work with Adobe Flash Media Server (FMS) to stream
Flash videos over Real Time Messaging Protocol™ (RTMP).
FMS RTMP delivery service listens on Transmission Control Protocol (TCP) port 1935; the
FMS administration service listens on TCP port 1111. RTMP is a proprietary protocol
developed by Adobe Systems for streaming audio, video and data over the Internet, between
a Flash player and a server.
•
"Installing FMS on Media Flow Controller (CLI)" on page 97
•
"Modifying and Restarting the FMS Service (CLI)" on page 99
•
"Configuring the FMS Admin Console—First Time (CLI)" on page 100
•
"Configuring FMS on Media Flow Controller for Video On Demand (CLI)" on page 100
•
"Applying the Adobe Full-Function FMS Server License (CLI)" on page 103

Installing FMS on Media Flow Controller (CLI)

To install FMS, you must first download the image; you can do this directly from Adobe (the
"Development Server" version, available for free, is adequate for this procedure, but it is
limited to 10 simultaneous streams). First download the image to a Web or FTP/SCP server to
which you have access. Use these CLI commands at the (config) # prompt (must have admin
privileges and enter enable and then configure terminal first):
application fms download <URL_of_FMS_image>
application fms install <name_of_FMS_image>
The download command downloads the image given in the URL (SCP, HTTP, or FTP) to the
directory /nkn/adobe/downloads directory that is visible in the FMS shell. See
on page 30
The install command shows files in the FMS download directory and, when the install image
is given, interactively installs FMS.
Important!
values; be sure to use these values as indicated in the following step procedure.
1. Accept the license agreement and enter your FMS server serial number or leave blank
and press Enter to install the FMS Development Server. The FMS Development Server is
free, but limited to 10 simultaneous streams.
Do you agree with the license agreement? (y/n): y
Please enter your Flash Media Server 3.5 serial number.
You have not entered a serial number.
Media Development Server!
Would you like to try again? y/n:
Adobe Flash Media Server 3.5 requires approximately 200MB of disk space.
2. Enter the correct directory for the installation, /nkn/adobe/fms.
The installer will install Adobe Flash Media Server 3.5 in the following
directory. Default [/opt/adobe/fms]: /nkn/adobe/fms
58.
for the scp URL format).
It is critical that a few of the installation questions are answered with the correct
Media Flow Controller Configuration Tasks (CLI)
"Before You Configure Media Flow
Falling back to the Adobe Flash
Default [n]: n
Installing and Using FMS in Media Flow Controller (CLI)
"Terminology"
97