Add Namespace; Configuration List; Namespace Configuration; Figure 51 Service Config > Namespace Page Detail (Add Namespace) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)

Add Namespace

Enter a name for the new namespace and click Add Namespace. See
Figure 51 Service Config > Namespace Page Detail (Add Namespace)

Configuration List

Select a namespace and click Configure to open a new window and make configurations;
click Show to see current settings; click Activate / Deactivate to take those actions. See
Figure 52.
Figure 52 Service Config > Namespace Page Detail (Configuration List)

Namespace Configuration

Use this window to configure a new namespace or make changes to an existing one. After
each configuration area, click Apply. When done click Done, at the page bottom. Namespace
configuration is broken into six areas:
•
"Configuring Namespace Origin Server (Web Interface)" on page 181
•
"Configuring Namespace HTTP Match Details (Web Interface)" on page 182
•
"Configuring Namespace Parameters (Web Interface)" on page 183
•
"Configuring Namespace Pre-Stage User (Web Interface)" on page 184
•
"Configuring Namespace HTTP Origin Fetch (Web Interface)" on page 184
•
"Configuring Namespace RTSP Origin Fetch (Web Interface)" on page 185
180 Configuring NameSpaces (Web Interface)
Media Flow Controller Administrator's Guide
Figure
Copyright © 2010, Juniper Networks, Inc.
51.