Email - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller CLI Commands
•
listen port
allowed. Default port for HTTP is 80; for RTSP is 554. Use no to reset default.
•
req-length maximum
(request line + headers) in bytes; requests larger than this size are rejected. Default is
16384 bytes; maximum allowed value is 32768.
•
trace
Specific Transaction" on page 281"
Note! If you change any delivery protocol options, you must run the
the delivery service: service restart mod-delivery.
show delivery protocol [http | rtsp]
Lists delivery protocol settings.

email

Configure email and event notification via email. See
Notifications (CLI)" on page 240
email
auth
enable
password
username
autosupport enable [event <event_name>]
dead-letter enable [cleanup max-age <duration>]
domain <hostname or IP_address>
mailhub <hostname or IP_address>
malhub-port <port>
notify
event <event_name>
recipient <email_address> [class [failure] [info]] [detail]
return-addr <username>
return-host
send-test
Notes:
•
—Set SMTP authorization parameters for email notifications.
auth
•
enable
disabled. Use no email auth to re-disable.
•
password
the user is prompted for the password.
authentication method supported is "LOGIN", which sends the password in the clear
(base64); so users should be aware that this involves some security risk.
•
username
•
autosupport
•
enable
vendor support when certain failures occur. Default is enable.
310 email
—Set the TCP port used to listen for requests; multiple entries (up to 64) are
—(http only) Set the maximum parse size for incoming requests
—(http only) Enable the Media Flow Controller HTTP delivery trace; see
—Enable SMTP authentication for Media Flow Controller emails; default is
—Set a password for SMTP authentication of emails; if no password is set,
—Set a username for SMTP authentication of emails.
—Sends emails to pre-configured vendor for certain failures.
—Enable or disable (with no email autosupport) the sending of email to
Media Flow Controller Administrator's Guide
for details on using the trace utility. Use no to disable.
"Configuring Media Flow Controller Fault
for task details.
Note! As of Release 2.0.4 the only
service
Copyright © 2010, Juniper Networks, Inc.
""Testing a
command for