Slogin; Snmp-Server - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
Note! Commands that would set something to its default are not included—so this command
on a fresh configuration produces no output, except the header.
Note! This does not include changes that have not yet been written to persistent storage.
show running-config [full]
The show running-config commands perform the same functions as the show
configuration commands and are included for ease-of-use.

slogin

slogin [<options>] <hostname>
EXEC command. Invokes the SSH client. You are returned to the CLI when SSH finishes.

snmp-server

Configure SNMP server options. To set trap event notification recipients, use the
commands.
Note! At this time, Media Flow Controller does not support provisioning over SNMP V3.
snmp-server
community <community_name> [ro]
contact <contact_name>
enable [communities] [traps]
host <IP_address>
disable
traps [version <trap_version> | 1 | 2c] [<community_string>]
listen [enable] [interface <interface_name>]
location <system_location>
traps event <event_name>
user {<user_name> | admin} v3
Notes:
•
community
requests. Default, and if unspecified, is ro. The read-only community means only queries
are performed. Use no to reset default.
is supported.
•
contact
•
enable
serving SNMP variables and the sending of SNMP traps.
•
communities
system. If disabled, the community configured is ignored.
•
traps
SNMP server must be enabled first. See
if there are trap sinks configured and enabled with snmp-server host.
•
host <IP_address>
•
disable
enabled. Use no snmp host <IP_address> disable to re-enable.
—Set a community name for either read-only (ro) or read/write (rw) SNMP
—Set (remove with no) the syscontact variable served from the System MIB in MIB-II.
—Enable the SNMP server. Use no snmp-server enable to disable; this stops
—Enable or disable (with no) community-based authentication on this
—Enable or disable (with no) sending SNMP traps from this system. The
—Add or delete (with no) hosts to receive SNMP traps.
—Temporarily disable sending traps to this host. All trap sinks are created
Media Flow Controller CLI Commands
Note! In Release 2.0.4 only SNMP ro (Read-Only)
"snmp traps," for details. Traps are only sent
email
slogin 353