Configuring Static Hosts And Arp (Web Interface); Configuring Static Hosts; Figure 18 Static Hosts Page - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide

Configuring Static Hosts and ARP (Web Interface)

Before you configure Media Flow Controller static hosts and ARP, see
Media Flow Controller" on page

Configuring Static Hosts

Set static host entries; a static host is not subject to IP address changes via DNS (dynamic
name sever.
To set static hosts:
•
From the left navigation pane in the System Config tab, select Hosts.
The Static Hosts page is displayed. See
Figure 18 Static Hosts Page
Static Host Entries
View configured static host entries, including IP address and Hostname. See
To delete a static host entry:
1. Click Remove Selected to delete any static host entries you have created.
2. Click Save at the top of the page to make changes persistent.
Add New Host
You must know the IP address and Hostname to enter a static host mapping. See
To add a new host:
1. Enter an IP address and Hostname. Click Add Entry to immediately apply changes.
2. Click Save at the top of the page to make changes persistent.
Media Flow Controller Configuration Tasks (Web Interface)
58.
Figure 18.
Configuring Static Hosts and ARP (Web Interface)
"Before You Configure
Figure 18.
Figure 18.
129