Figure 30 Logging Page Detail (Log Format) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
Remote Log Sinks
View and delete configured log sinks (remote servers receiving log messages from this
system). See
1. View this information:
• Remote Sink—Address of configured Remote Sink.
• Minimum Severity—The configured log severity level for this Remote Sink.
2. To delete a log sink, select a log sink and click Remove.
3. Click Save at the top of the page to make changes persistent across reboots.
Add New Remote Sinks
Add new remote sinks (remote servers receiving log messages from this system). See
Figure 29.
To add a new remote sink:
1. Enter an IP address.
2. Choose a Minimum Severity level (described in
3. Click Apply to add the new remote sink, Cancel to revert to existing configuration.
4. Click Save at the top of the page to make changes persistent across reboots.
Log Format
Configure a log format. See
Figure 30 Logging Page Detail (Log Format)
To set a log format:
1. Choose either Standard (default) or WELF (Web trends Enhanced Log Format). If you
choose WELF, a WELF firewall name option is displayed; specify the firewall name that
should be associated with each message logged in WELF format. If no firewall name is
set, the hostname is used by default.
2. Click Apply to set the format, Cancel to revert to existing configuration.
3. Click Save at the top of the page to make changes persistent across reboots.
Figure 29.
Figure 30.
Media Flow Controller Configuration Tasks (Web Interface)
"Local Log Filtering" on page
Configuring SNMP, Faults, and Logging (Web Interface)
150).
151