Configuring Ntp (Web Interface); Figure 21 Ntp Page - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)
2. Choose a Time Zone from the drop-down list.
3. (Optional) Click the enabled link to jump to the NTP page.
4. Click Apply to set the date, time, and time zone; Cancel to revert to existing configuration.
5. Click Save at the top of the page to make changes persistent across reboots.

Configuring NTP (Web Interface)

Configure Network Time Protocol (NTP) options.
To configure NTP servers:
•
From the left navigation pane in the System Config tab, select NTP.
The NTP page is displayed. See
Figure 21 NTP Page
132 Configuring Date, Time, and NTP (Web Interface)
Media Flow Controller Administrator's Guide
Figure 21.
Copyright © 2010, Juniper Networks, Inc.