Table of Contents
Advertisement
Media Flow Controller Configuration Tasks (Web Interface)
•
Retransmit—The number of times the client attempts to authenticate with any
RADIUS server. Range is 0-5, default is 1.
•
Login-lat-group—The string that identifies the groups that the user is authorized to
use when Login-service is defined as LAT (local area transport). If none is set, the
user is prompted for the string.
2. Click Apply to immediately apply changes; Cancel to reset previous values.
3. Click Save at the top of the page to make changes persistent across reboots.
RADIUS Servers
In the server list: Remove, Enable or Disable RADIUS Servers. See
1. View this information on configured RADIUS servers:
•
Server—The configured IP address for this RADIUS server.
•
Auth-Port—The configured port for authentication requests to this server.
•
Key— The configured shared secret text string. If empty, the user is prompted for the
key.
•
Timeout—The configured timeout for retransmitting a request.
•
Retransmit—The configured number of times a client may attempt to authenticate.
•
Login-lat-group—The configured string that identifies the groups that the user is
authorized to use when Login-service is defined as LAT (local area transport).
•
Enabled—Whether or not this RADIUS server is enabled. Disabling a server makes it
inactive but does not delete it from the system.
2. Select a server and Remove Selected Server, Enable Server, or Disable Server.
3. Click Save at the top of the page to make changes persistent across reboots.
Add New RADIUS Server
Add a new RADIUS server. See
1. Select Enabled—The server must be enabled to do authentication.
2. Enter this information to the text boxes:
•
Server IP—IP address for the server.
•
Auth Port—The port for authentication requests; default is 1812. You can use the
same IP address in more than one host as long as the auth-port is different.
3. (Optional) Enter overrides for Key, Timeout, Retransmit, and Login-lat-group values for
this RADIUS server from the default RADIUS settings you made above.
4. Click Add RADIUS Server to complete operation.
5. Click Save at the top of the page to make changes persistent across reboots.
Configuring TACACS+ (Web Interface)
Configure TACACS+ authentication options.
To configure TACACS+:
•
From the left navigation pane in the System Config tab, select TACACS+.
The TACACS+ page is displayed. See
136
Configuring RADIUS, TACACS+, and SSH (Web Interface)
Media Flow Controller Administrator's Guide
Figure
22. To add and enable a new RADIUS server:
Figure
23.
Figure
22.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
