Figure 12 Network Interfaces Page Detail (Eth0 State And Eth0 Configuration) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Configuration Tasks (Web Interface)
Figure 12 Network Interfaces Page Detail (eth0 state and eth0 configuration)
eth0 state
View the state of the eth0 interface, see
To view the eth0 state area:
Status (Admin up: The interface is enabled, Link up: The interface has a current
connection), IP address, Netmask, Type, Speed, Duplex, MTU, HWaddr (hardware
address), and a Comment (if configured) for each discovered interface.
eth0 configuration
The eth0 interface is set up to be used to manage Media Flow Controller. See
Important!
mappings, all interface assignments are handled automatically during manufacturing.
To configure the eth0 interface:
1. Enter information in the text box:
• Enabled—Select to enable the interface for activity, default; or de-select the checkbox
to disable the interface, respectively.
• Obtain IP Address Automatically (DHCP)—Allow DHCP to assign the IP address
for this Media Flow Controller. OR
120 Configuring Interfaces, Default Gateway, Static Routes, DNS and Domain Names, Hostname and Banners
For VXA Series Media Flow Engine appliances, do not ever change the eth name
Media Flow Controller Administrator's Guide
Figure 12.
Figure 12.