Logging In To Media Flow Controller For The First Time (Web Interface) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
Related Topics
•
"How Media Flow Controller Works" on page 43
•
"Media Flow Controller Functions Overview" on page 45
Logging In to Media Flow Controller for the First Time (Web
Interface)
Before you log in to Media Flow Controller for the first time, see
Flow Controller" on page
To log into the Media Flow Controller Web interface for the first time, you need the IP address
assigned the eth0 management interface.
1. Open a browser and enter the Media Flow Controller management IP address including
the management port, 8080. For example:
http://192.168.1.100:8080
2. Log in with these default credentials (there is no default password).
User: admin
The Monitoring Summary page is displayed.
Configuring Media Flow Controller for the First Time (Web
Interface)
The EZconfig tab allows you to easily set up Media Flow Controller for the first time.
See Figure 8, "EZ Config Tab Page Detail (missing Enable Interfaces and Service Restart
areas)," on page 112
•
"Setting the System Hostname (EZconfig)" on page 113
•
"Setting Network Parameters (EZconfig)" on page 113
•
"Creating a Virtual Player (EZconfig)" on page 113
•
"Adding a Namespace (EZconfig)" on page 114
•
"Enabling Interfaces (EZconfig)" on page 114
•
"Restarting Services (EZconfig)" on page 114
Media Flow Controller Configuration Tasks (Web Interface)
58.
for a screenshot of the EZ Config page.

Logging In to Media Flow Controller for the First Time (Web Interface)

"Before You Configure Media
111