Table of Contents
Advertisement
Media Flow Controller Configuration Tasks (Web Interface)
•
Retransmit—The number of times the client attempts to authenticate with any
TACACS+ server. Range is 0-5, default is 1.
2. Click Apply to immediately apply changes; Cancel to reset previous values.
3. Click Save at the top of the page to make changes persistent across reboots.
TACACS+ Servers
In the server list: Remove, Enable or Disable TACACS+ Servers. See
1. View this information on configured TACACS+ servers:
•
Server—The configured IP address for this TACACS+ server.
•
Auth-Port—The configured port for authentication requests to this server.
•
Auth-Type—The configured type of authentication this TACACS+ server will use.
•
Key— The configured shared secret string. If empty, the user is prompted for the key.
•
Timeout—The configured timeout for retransmitting a request.
•
Retransmit—The configured number of times a client may attempt to authenticate.
•
Enabled—Whether or not this TACACS+ server is enabled. Disabling a server makes
it inactive but does not delete it from the system.
2. Select a server and Remove Selected Server, Enable Server, or Disable Server.
3. Click Save at the top of the page to make changes persistent across reboots.
Add New TACACS+ Server
Add a new TACACS+ server. See
1. Select Enabled—The server must be enabled to do authentication.
2. Enter this information to the text boxes:
•
Server IP—IP address for the server.
•
Auth Port—The port for authentication requests; default is 49. You can use the same
IP address in more than one host as long as the auth-port is different.
•
Auth Type—Which type of authentication this TACACS+ server will use; both
authentication types transmit the username and password in un-encrypted text and
are acceptable when passwords are stored in an external database. Choose either:
•
•
3. (Optional) Enter overrides for Key, Timeout, Retransmit, and Login-lat-group values for
this TACACS+ server from the default TACACS+ settings you made above.
4. Click Add TACACS+ Server to complete operation.
5. Click Save at the top of the page to make changes persistent across reboots.
Configuring SSH (Web Interface)
Configure Secure Sockets Shell (SSH) transmissions. SSH is protocol to secure connections
through an encryption known to the server and the client. The encryption operates via Host
138
Configuring RADIUS, TACACS+, and SSH (Web Interface)
ascii—American Standard Code for Information Interchange.
pap—Password authentication protocol (default).
Media Flow Controller Administrator's Guide
Figure
23. To add and enable a new TACACS+ server:
Figure
Copyright © 2010, Juniper Networks, Inc.
23.
Advertisement
Chapters
Table of Contents
Troubleshooting
